Filter
Top Products
FARGO Electronics Inc.
HDP700 Series Card Printer 4-1
Section
4
Parts Replacement
This Section guides you through the replacement of key components of the card printer. Be sure to
reverse the disassembly steps to reassemble the card printer.
Safety Messages
Procedures and instructions in this Section may require special precautions to ensure the safety of the
personnel performing the operations. Information that raises potential safety issues is indicated by a
warning symbol (as shown to the below).
Refer to the following safety messages before performing an operation preceded by this symbol.
DANGER
Failure to follow these installation guidelines can result in death or serious injury. Always remove the power
cord prior to performing repair procedures, unless otherwise specified. Make sure only qualified personnel
perform these procedures.
Procedures and instructions in this Section may require special precautions to ensure the safety of the
personnel performing the operations. Information that raises potential electrostatic safety issues is indicated
by a warning symbol (as shown to the below).
Refer to the following safety messages before performing an operation preceded by this symbol.
CAUTION
This device is electrostatically sensitive. It may be damaged if exposed to static electricity discharges. Be sure
to observe all established Electrostatic Discharge (ESD) procedures while handling cables in or near the
Circuit Board and Printhead Assemblies. Always wear an appropriate personal grounding device, such as a
high quality wrist strap grounded to avoid potential damage.
IMPORTANT
Always remove the HDP ribbon, HDP Film and cards from the printer before making any repairs, unless
otherwise specified. Remove jewelry from hands and wash them.