Filter
Top Products
FARGO Electronics Inc.
HDP700 Series Card Printer 4-43
4. Remove the five screws from the base of the Card Input Hopper Cover and remove the other
four screws (on the right side) of the printer.
5. Lift the Card Input Hopper Cover off of the printer.
6. Use the small standard screwdriver to remove the Retaining Ring (140062) from the Card
Feed Shaft Gear.
7. Remove the three screws (130315) from the Card Feed Motor Assembly.
8. Lift the Card Feed Motor Assembly from the printer.
4.8.10 Clutch Spring
(840285)
Refer To Drawing 840156
Tools Needed
Phillips-head Screwdriver, Small Standard Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Detach the LCD Interface Cable (D840517) from the HD7XXX User Interface Board
Assembly (140403).
4. Remove the five screws from the base of the Card Input Hopper Cover and remove the other
four screws from inside the print station.
5. Lift the Card Input Hopper Cover off of the printer.
6. Use the small standard screwdriver to remove the Retaining Ring (140062) from the one-way
Pulley (840215).
7. Slide the one-way pulley from the shaft.
8. Slide the Clutch Spring (840285) from the shaft.
4.8.11 Card Sensor Assembly-Flipper Table
(D840624)
Refer To Drawing 840156
Tools Needed
1.5mm Allen Wrench, Phillips-head Screwdriver, Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Detach the LCD Interface Cable (D840517) from the HD7XXX User Interface Board
Assembly (140403).
4. Remove the five screws from the base of the Card Input Hopper Cover and remove the other
four screws from inside the print station.
5. Lift the Card Input Hopper Cover off of the printer.
6. Loosen the belt tensioner
7. Remove the pulley from the front of the printer.