Filter
Top Products
FARGO Electronics Inc.
HDP700 Series Card Printer 4-17
4.5.7 Upper Film Sensor Assembly
(D841023)
Refer To Drawing 840152
Tools Needed
Phillips-head Screwdriver, Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Push the Release Lever down to unlock it.
4. Lift the Print Station up and back.
5. Bring the Transfer Station up and forward.
6. Remove the four screws (F000034) from the Front Cover.
7. Lift off the Front Cover.
8. Remove the screw (F000191) that holds the bracket (D840122) in place.
9. Disconnect the cable connector from the board.
10. Remove the three screws (F000191) from the sensor board.
4.5.8 Print Platen Roller
(840319)
Refer To Drawing 840152
Tools Needed
Phillips-head Screwdriver, Standard Screwdriver, 1.5 mm Allen Wrench
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Push the Release Lever down to unlock it.
4. Lift the Print Station up and back.
5. Bring the Transfer Station up and forward.
6. Remove the four screws (F000034) from the Front Cover.
7. Lift off the Front Cover.
8. Remove the two screws (F000034) from the Rear Transfer Cover.
9. Lift off the Rear Transfer Cover.
10. Use the standard screwdriver to remove the Retaining Ring (140065) and Ribbon Roller
Bearing (760219) from the front side of the Platen Roller.
11. Loosen the two screws that secure the belt tensioner (D840864).
12. Remove the pulley (F000006).
13. Take off the Ribbon Roller Bearings (760219) that secure the shaft to the printer frame.