Filter
Top Products
FARGO Electronics Inc.
4-26 HDP700 Series Card Printer
14. Take the Spring Plate from the printer.
4.6.6 Pinch Roller Spring Plate-Back -- 2
(840354)
Refer To Drawing 840151
Tools Needed
Long-handled, magnetic Phillips-head Screwdriver, Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Remove the screws from the Back Cover of the printer.
3. Tilt the Back Cover outwards from the printer.
4. Remove the four screws that secure the Rear Bracket (D840585) to the printer.
5. Detach the cables running to the board.
6. Remove the screw from the Gas Spring (840366) and take off the Washers (130283 and
140040).
7. Set the Back Cover carefully aside.
8. Remove the screw from the Spring Plate
9. Take the Spring Plate from the printer.
4.6.7 Drive Belt-Tensioner to Platen Roller
(F000003)
Refer To Drawing 840151
Tools Needed
Standard Screwdriver, Torx T-10 Screwdriver, Phillips-head Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Remove the screws from the Back Cover of the printer.
3. Tilt the Back Cover outwards from the printer.
4. Remove the four screws that secure the Rear Bracket (D840585) to the printer.
5. Detach the cables running to the board.
6. Remove the screw from the Gas Spring (840366) and take off the Washers (130283 and
140040).
7. Set the Back Cover carefully aside.
8. Loosen the two screws to the tensioner.
9. Pull the tensioner back against spring to relieve tension from the belt.
10. Remove the belt from the pulley.