Filter
Top Products
FARGO Electronics Inc.
A-6 HDP700 Series Card Printer
Inches: 40 – (Distance x 300):
Millimeters: 40 – (Distance x 11.8):
Example: Inches: 40 – (.020 x 300) = 34:
7. Adjust the Print Offset value.
8. Press SELECT to save the value.
9. Print a test card as described in step 1.
10. Repeat steps 1 to 9 until the test image is correctly positioned. Refer to Figure 7-2.
NOTE:
If further adjustment is needed, decrease the Print Offset value to move the printed image
toward the leading edge of the card; increase the Print Offset value to move the printed image
toward the trailing edge of the card. Remember, ±30 pixels will move your image 0.100 in. or
3.84mm.
7.3.4 Setting the Transfer TOF
This procedure positions the HDP Film correctly on the leading edge of the card. Refer to Section
7.3.1 for proper sequence.
1. Choose MENU, Print Test Image, and Gray/Align YMC to print a test card.
2. Examine the test card. The Inner Alignment Arrows should appear at the edge of the leading
edge; the Outer Alignment Arrows should not appear on the card, but are shown here for
clarity. If your test card does not look like Figure 7-7, go to step 5 to adjust the Transfer
TOF.
3. Record the Transfer TOF value on the test card last printed.
4. Select MENU, Setup Printer, and Transfer TOF.