Filter
Top Products
FARGO Electronics Inc.
HDP700 Series Card Printer 4-45
4. Remove the five screws from the base of the Card Input Hopper Cover and remove the other
four screws from inside the print station.
5. Lift the Card Input Hopper Cover off of the printer.
6. Remove the two screws (F000191) that secure the access plate to the base of the printer.
7. Use the standard screwdriver to remove the two c-clips from the posts.
8. Remove the springs
9. Disconnect the cable connector
10. Lift the Magnetic Encoder Head from the printer.
4.8.14 Encoder Card Sensor
(140407)
Refer To Drawing 840156
Tools Needed
Torx T-10 Screwdriver, 7/32 in. Nut driver
1. Turn off the printer and unplug the power cord from the printer.
2. Remove the two screws from the access panel on the underside of the baseplate.
3. Remove the two nuts that hold the sensor in place.
4. Disconnect the cable connector.