Filter
Top Products
FARGO Electronics Inc.
HDP700 Series Card Printer 4-49
4.10.2 Stacker Full Sensor
(140407)
Refer to Drawing D840590
Tools Needed
Phillips-head Screwdriver, Torx T10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Remove the four screws from the bottom edge of the Card Input Hopper Cover and the three
screws from the inside edge of the cover (on the left side) of the printer.
3. Lift the Card Output Hopper Cover off of the printer.
4. Remove the two screws from the sensor.
5. Disconnect the cable connector.
4.10.3 Stacker Lift Motor
(840130)
Refer to Drawing D840590
Tools Needed
Phillips-head Screwdriver, Torx T10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Remove the four screws from the bottom edge of the Card Input Hopper Cover and the three
screws from the inside edge of the cover (on the left side) of the printer.
3. Lift the Card Output Hopper Cover off of the printer.
4. Remove the o-ring from the motor.
5. Remove the two screws that hold the motor in place.
6. Disconnect the wires from the Stacker Lift Motor.
7. Lift the motor from the printer.