Filter
Top Products
FARGO Electronics Inc.
HDP700 Series Card Printer 4-13
4.4.8 Ribbon Supply Encoder Sensor Assembly
(D840982)
Refer To Drawing 840153
Tools Needed
Small Standard Screwdriver, Phillips-head Screwdriver, Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Push the Release Lever down to unlock it.
4. Lift the Print Station up and back.
5. Remove the four screws (F000034) from the Print Station Cover of the printer.
6. Lower the Print Station back into position.
7. Lift the Print Station Cover off of the printer.
8. Use the small standard screwdriver to remove the Retainer Clip (897144) from the Encoder
Wheel (810492).
9. Take the Washer (130997) from the Encoder Wheel (810492).
10. Guide the Encoder Wheel (810492) gently off of the shaft.
11. Remove the two screws (F000172) from the Ribbon Supply Encoder Sensor Assembly.
12. Disconnect the cable connector.
13. Remove the Ribbon Encoder Sensor Assembly.
4.4.9 Headlift Sensor Assembly
(D840983)
Refer To Drawing 840153
Tools Needed
Phillips-head Screwdriver, Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Push the Release Lever down to unlock it.
4. Lift the Print Station up and back.
5. Remove the four screws (F000034) from the Print Station Cover of the printer.
6. Lower the Print Station back into position.
7. Lift the Print Station Cover off of the printer.
8. Remove the two screws (F000169) that secure the Headlift Sensor Assembly.
9. Disconnect the cable connector.
10. Feed the cable out through the access hole.