Filter
Top Products
Section 4: Ribbons and Cards 23
Pro-L Card Printer Users Manual
4. With the cover open, place the supply end of the ribbon in between the two
black Ribbon Drive Hubs located on the far right-hand side of the printers
interior. Make certain that the ribbon is fed from underneath the ribbon roll.
HINT: The Ribbon Drive Hub nearest you, as you are looking into the printer
from the front, is spring loaded. Use the end of the ribbon supply core to push
in this Ribbon Drive Hub when inserting the ribbon.
5. Place the take-up end of the ribbon roll in between the two black Ribbon Drive
Hubs located about six inches (152mm) to the left of the ribbon supply Ribbon
Drive Hubs. Load the ribbon take-up end of the ribbon just as you loaded the
ribbon supply end in step 4. When loaded properly, the ribbon should feed
underneath both ends of the ribbon roll.
6. Close the cover. When you start to print, the Ribbon Drive Hubs will
automatically engage the ribbon core notches.
IMPORTANT!
Do not reverse the ribbon. Damage may occur to the thermal printhead!
Take-up Ribbon
Drive Hubs
Supply Ribbon
Drive Hubs
Ribbon
Sensor
Supply Roll
Cleaning Roller Assembly
Take-up Roll
proL.qxd 8/6/2000 3:30 PM Page 23