Filter
Top Products
54 Section 7: Maintenance
Pro-L Card Printer Users Manual
3. Insert the Cleaning Card into the Card Hopper as you normally would any
other type of card. Be sure, however, that the shortest non-adhesive end of the
Cleaning Card enters the printer first and that the side of the cleaning card
with the adhesive backing removed (the sticky side) is facing upward. If the
card is inserted with the sticky side facing downward, it will stick to the Card
Input Tray and will not feed.
4. Once the Cleaning Card is properly inserted into the Card Hopper, hold down
the On/Cancel button and push the Cleaning Card into the printer until you
feel the second gray feed roller grab and begin feeding the card.
5. Continue to hold down the On/Cancel button until the Cleaning Card has fed
completely through the printer. Repeat this cleaning procedure if necessary.
After the cleaning procedure is finished, re-install media, close the printers
Top Covers, and turn the printer power OFF and ON to reset the printer.
NOTE:
Once you have completed the above cleaning procedure, you should also clean the printers
Drive Rollers and Cleaning Roller Assembly according to the steps in the next procedures.
I. CLEANING THE DRIVE ROLLERS
The printers Drive Rollers should be cleaned during every ribbon change or after
every 250 prints. This helps to prevent jams and maintain uninterrupted service.
Also perform this procedure if the roller is visibly dirty. Use the following steps to
clean the roller:
1. Leave the printer power ON, and open the Top Covers of the printer.
2. Remove the ribbon rolls and overlaminate rolls.
3. Locate the Drive Rollers.
4. Use a Cleaning Pad from the Printer Cleaning Kit or a soft, lint-free cloth
slightly moistened with isopropyl alcohol to wipe the rollers clean. Press the
On/Cancel and Pause/Resume buttons to move the rollers back and forth
while cleaning.
5. Replace the print supplies and close the printers covers.
Insert This End First
Sticky Side Up
proL.qxd 8/6/2000 3:30 PM Page 54