Filter
Top Products
Section 8: Mechanical Adjustments 57
Mechanical
Adjustments
The printer is pre-set at the factory to consistently feed and print a standard CR-80
3.375L x 2.125W x .030 (86mmL x 54mmW x .75mm) card size. When inserting
cards which vary from this standard card size, one should make slight adjustments
to the Card Input Guides and to the Card Separator Flap for consistent card
feeding and for best output quality. This section explains how to make these
adjustments and also how to adjust the printers built-in laminator for optimizing
placement of the PolyGuard overlaminate.
A. ADJUSTING THE CARD INPUT GUIDES
Two Card Input Guides reside within the Card Hopper. The left Card Input Guide,
as you are looking straight into the Card Hopper, is adjustable to accommodate
varying card widths. To adjust this Card Input Guide, refer to the following steps:
8
Card Input Guides
Left Card Input
Guide Screws
Card Hopper Door
proL.qxd 8/6/2000 3:30 PM Page 57