Filter
Top Products
BOTTOM Line of LCD (continued)
Message Cause Solution
Lam Jam/Out The overlaminate has If jammed, clear it according
become jammed in the to the instructions in
printer rollers, is stuck Section 7-G. If out, install
to the surface of the card more overlaminate
is broken, or has run out. (see Section 5-C). Press the
Pause/Resume button to
continue.
Lam Ready Indicates printer is ready to
laminate.
Lam Turned Off Indicates laminator is OFF.
The laminator can be
turned off by setting
switches 4 & 5 of the
printers internal switches
down (towards the circuit
board).
Laminating Indicates printer is
laminating.
Roller-dn Failed Lamination roller is unable Press Pause/Resume button
to lower. to retry. If failure continues
call for technical assistance.
Roller-up Failed Lamination roller is unable Press Pause/Resume button
to raise. to retry. If failure continues
call for technical assistance.
Sensor Calibrate Indicates the Lamination
Sensor is calibrating.
Wrong Lam Type The wrong overlaminate is Check that you have the
installed. proper overlaminate
installed according to the
Lamination option selected
in the printer driver setup
window (see Section 6-D).
74 Section 9: Troubleshooting
Pro-L Card Printer Users Manual
proL.qxd 8/6/2000 3:30 PM Page 74