Filter
Top Products
RPM4™ OPERATION AND MAINTENANCE MANUAL
© 2004-2007 DH Instruments, a Fluke Company Page 140
PM
Pressure multiplier, used to adjust span of a Q-RPT or barometer to calibrate it.
Parallel Measurement
Mode
Operating mode of RPM4s with two Q-RPTs in which both Q-RPTs are used to measure
together in parallel and the indicated pressure is the average of their readings. This
creates a pseudo Q-RPT designated HL.
Pmax!
The maximum pressure limit of a Q-RPT. If the pressure measured by the Q-RPT
exceeds Pmax!, an overpressure condition occurs.
PPC3
Pressure controller calibrator manufactured by DHI. RPM4 can be used as an external
reference device for a PPC3. PPC3 automates RPM4 pressure control.
Q-RPT
(Quartz Reference
Pressure Transducer)
The transducer used by RPM4 for low uncertainty pressure measurement. May be
designated as Hi, Lo or HL depending on its position and role in t he RPM4.
Q-RPTs are designated by a leading A, G or BG (absolute, gauge or bi-directional
gauge) followed by three numbers and a letter indicating the maximum range of the
Q-RPT in kPa (nnnK) or MPa (nnnM).
Rate
A DISPLAY function in which the rate of change of pressure in pressure unit/second is
displayed.
Ready/Not Ready
Front panel LED indication of when the pressure measured by RPM4’s active Q-RPT is
stable within the stability limit. Leading character of the second line when the inactive Q-
RPT is displayed on the second line in RPT DISPLAY mode.
RPT2x
Parallel measurement mode in which both Q-RPTs of an RPM4 with two Q-RPTs are
used together and the indicated pressure is the average of their measurements.
SDS (Self Defense
System)
A system to protect Q-RPTs from overpressure made up of isolation and vent valves
and internal operating logic. Applies only to Q-RPTs designated A7M or lower.
Span
The difference between FS and the lowest point in a range. For example, the span of a
100 kPa FS range in negative gauge mode is nominally 200 kPa (from - 100 kPa to 100 kPa).
Stability Limit
A limit expressed in units of pressure per second (e.g., kPa/second). The stability limit is used
as the Ready/Not Ready criterion. Ready if rate of change is less than stability limit.
Not Ready if rate of change is greater than stability limit.
Target
The value from which deviations are measured in the Deviation DISPLAY function.
UL (Upper Limit)
A user settable maximum pressure limit. When pressure exceeds UL, RPM4 beeps
intermittently. In negative gauge measurement mode, there is also a user settable lower limit.
User Level
Levels of security that can be set to protect certain RPM4 functions from being accessed.
QDUT
On-board automated test sequence that AutoRanges RPM4 based on characteristics of
the Device Under Test (DUT).