Filter
Top Products
U41243-J-Z156-1-76 43
Preparation for use and operation Cleaning the server
Password Clear:
This switch controls whether the current password is retained or cleared when
the system is reset.
If you want to change the current password, proceed as follows:
Ê Follow the procedure described in the section “Changing the switch
settings”.
Ê Set DIP switch 3 (see table 2 on page 38) to ON.
Ê Switch the system on. Wait for POST to complete. This clears the current
password.
Ê Shut down the system, turn the server off and disconnect it from the line
voltage.
Ê Reset DIP switch 3 (see table 2 on page 38) to OFF.
Ê Reconnect all peripheral devices, reconnect the server to the line voltage,
and switch the server on.
Ê Run BIOS Setup to enter a new password (see section “BIOS Setup” on
page 47).
4.5 Cleaning the server
V CAUTION!
Switch off the server and pull the power plugs from the grounded
insulated sockets.
Only authorized service personnel are allowed to clean inside the server.
Do not use any cleaning agents that contain abrasives or may corrode
plastic.
Ensure that no liquid enters the system and that the ventilation areas of
the server and monitor remain clear.
You can use a disinfection cloth to clean the outside of the keyboard and the
mouse.
Wipe the server and monitor casing with a dry cloth. If particularly dirty, use a
cloth that has been moistened in mild domestic detergent and then carefully
wrung out.