Filter
Top Products
U41243-J-Z156-1-76 45
5 Configuration software and
utilities
This chapter describes the Power-ON Self-Test (POST) and the configuration
software.
5.1 Short cuts using a key combinations
Use the numeric pad on the keyboard to enter numbers and symbols.
5.2 Power-ON Self-Test (POST)
Every time you turn on the system, the POST starts. It checks the boards,
processors, memory, keyboard and most installed devices. During the memory
test, POST displays the amount of memory it is able to access and test. The
length of time needed to test memory depends on the amount of memory
installed. POST is stored in flash memory.
Ê Turn on your monitor and the system. POST starts up after a few seconds.
After the memory test, the following screen prompts and messages are
displayed:
Keyboard Detected
Mouse Initialized
Press
[F2] to enter Setup
Key combinations
Clear memory and reload the
operating system, i.e. system reset
[Ctrl]+[Alt]+[Del]
Save system immediately [Ctrl]+[Alt]+hotkey (set your hot-key
combination with BIOS Setup.)
Call BIOS Setup during POST [F2]
Table 3: Key combinations