Filter
Top Products
U41243-J-Z156-1-76 71
Configuration software and utilities Utilities
5.4.2.3 Recovering BIOS
Although it is unlikely that the BIOS update process will be interrupted, BIOS
could be damaged if an interruption does occur. In this case, you must recover
BIOS.
I Because of the small amount of code available in the non-erasable boot
block, there is no graphics support. Therefore, you will not see anything
on the screen during this procedure. You can monitor the procedure by
listening to the beeps and looking at the LED on the floppy disk drive.
The procedure for recovering BIOS is described in detail in the section
“Changing the switch settings” on page 39. After completing the
procedure, leave the update disk in drive A and turn on the server. Then
continue with the procedure for updating BIOS.
5.4.2.4 Changing the BIOS language
You can use the BIOS update utility to change the language used for BIOS
display. Use a bootable floppy disk containing the flash utility and language files.
Ê Boot the server with the bootable floppy disk in drive A. The user interface
for the BIOS update utility is displayed on the screen.
Ê Select Update Flash Memory From a File and then Update Language Set. Then
press Ú.
Ê Use the arrow keys to select the appropriate lng file. Press Ú.
Ê When asked to confirm that you want to overwrite the old language in
memory with the new language, select Continue with Programming and press
Ú.
Ê When the message Upgrade is Complete is displayed, remove the floppy disk
from drive A and press Ú.
The computer will reboot and the changes will take effect.