Filter
Top Products
Chapter 2: Installing and Setting Up your Autoloader www.gateway.com
32
To stop Sequential mode operation:
1 From the Main menu, scroll to Commands, then press ENTER. The
Commands submenu opens.
2 Scroll to Sequential Ops, then press ENTER. The Sequential Ops submenu
opens.
3 Scroll to Stop, then press ENTER. “Ejecting tape from drive” appears on the
LCD.
To resume Sequential mode operation:
1 From the Main menu, scroll to Commands, then press ENTER. The
Commands submenu opens.
2 Scroll to Sequential Ops, then press ENTER. The Sequential Ops submenu
opens.
3 Scroll to Resume, then press ENTER. “Moving next tape to drive” appears
on the LCD.
Setting security
You can add security to the front panel by password-protecting the autoloader's
functionality. The security setting only protects the front panel functionality.
The default setting is Off, meaning that no password is required. However, you
can enable the security option so that users must enter a password to access
functionality.
Security option
When you first turn on the autoloader, the security option is set to Off. Use the
following procedure to enable the security option. You must have an
administrator-level password to set passwords.
To set the Security option:
1 From the Main menu, scroll to Configuration, then press ENTER. The
Configuration submenu opens.
2 Scroll to Security. If a check mark appears after the word Security, the
security option is On. If no check mark appears, the security option is Off.
3 To change the option, press ENTER. For example, if the security option was
set to On, it is now set to Off, and no check mark appears.
Setting magazines
In some cases, autoloader owners have been charged Independent Software
Vendor (ISV) licensing fees for two-magazine SuperLoader 3s, even though only
one magazine was configured. This happened because the ISV software
registered the autoloader as a two-magazine device, regardless of the number
of magazines actually configured. You can set the number of magazines in the
autoloader.