Filter
Top Products
Using magazines and magazine blanks
www.gateway.com
45
To change the orientation of a magazine or magazine blank:
1 Remove the magazine or magazine blank from the autoloader, if it is
installed.
2 Remove the two screws that attach the handle to the front of the magazine
or magazine blank.
3 Unsnap the handle carefully, being careful not to break the hinge.
4 Rotate the magazine or magazine blank 180 degrees so that what was the
front of the magazine is now the back.
5 Attach the appropriate left or right handle to the front of the rotated
magazine or magazine blank by snapping the handle onto the front of the
magazine or magazine blank.
6 Install the two screws to attach the handle securely to the magazine or
magazine blank.
Manually operating the magazine
Caution
We recommend that you fully remove the
magazine to load and unload cartridges.
Damage to the magazine or the
cartridge could result if you rotate the
magazine before it is fully removed.
There are two knobs on the side of the magazine opposite the side with the
cartridge slots, one on each end. You can move the slots within the magazine
by turning these two knobs and aligning a slot with one of the two openings.
You can use the openings in the magazine to load and unload cartridges from
the eight slots within each magazine.
Screws