Filter
Top Products
reference guide
load originals and load paper
13
load originals & paper
load the input tray
1 Remove the output tray, and slide the paper-width and paper-length guides
to their outermost positions.
2 Tap a stack of paper on a flat surface to align the edges, and then check to
make sure all of the paper in the stack is the same size and type.
3 Slide the short edge of the paper forward into the input tray with the print
side down until it stops. If you are using letterhead, insert the top of the
page first with the print side down.
4 Slide the paper-width and paper-length guides inward until they stop at the
edges of the paper. Make sure that the paper stack lies flat in the input tray
and is stacked no higher than the paper-length guide.
5 Replace the output tray.