Filter
Top Products
hp psc 2400 series
chapter 6
70
fax
set tone or pulse dialing
You can set the dial mode for tone or pulse dialing. Most phone systems work
with either tone or pulse dialing. If you have a public phone system or a private
branch exchange (PBX) system that requires pulse dialing, you will need to select
Pulse Dialing. The default setting is Tone Dialing. Some phone system features
might not be accessible if pulse dialing is used. In addition, it can take longer
to dial a fax number with pulse dialing. Contact your local phone company if
you are unsure which setting to use.
Note: If your phone system does not require pulse dialing, we recommend
using the default setting of Tone Dialing.
1 Press Setup.
2 Press 3, then press 5.
This selects Basic Fax Setup and then Tone or Pulse Dialing.
3 Press to highlight an option, and then press OK.
set backup fax reception
Use the Backup Fax Reception feature to store received faxes in memory. For
example, if your print cartridge runs out of ink while receiving a fax, the fax will
be stored in memory. Then, after you have replaced the print cartridge, you can
print out the fax. The color graphics display notifies you when there are faxes
stored in memory that need to be printed.
By default, Backup Fax Reception feature is enabled. For information on printing
faxes stored in memory, see reprint the faxes in memory on page 70.
Your HP PSC can store up to 60 pages in its memory, with the number of pages
depending on the model you purchased. As the memory becomes full, the
HP PSC overwrites the oldest, printed faxes.
Note: All unprinted faxes will remain in memory until they are printed or
deleted. When the memory becomes full of unprinted faxes, the HP PSC
will not receive any more fax calls until the unprinted faxes are printed. To
delete all faxes in memory, including the unprinted faxes, turn off your
HP PSC.
1 Press Setup.
2 Press 4, then press 6.
This selects Advanced Fax Setup and then Backup Fax Reception.
3 Press to select On or Off.
4 Press OK.
reprint the faxes in memory
Reprint Faxes in Memory enables you to reprint a fax stored in memory. Any
time the HP PSC begins printing a fax you do not need, press Cancel to stop it
from printing. The HP PSC begins printing the next fax in memory. You will need
to press Cancel for each stored fax in order to stop it from printing.
Note: All faxes stored in memory will be lost if you turn off the power to
your HP PSC.