Filter
Top Products
reference guide
load originals and load paper
15
load originals & paper
load 4 by 6 inch (10 by 15 cm) photo paper
The following describes the procedure for loading 4 by 6 inch (10 by 15 cm)
photo paper into your HP PSC.
Note: For the best results, use a recommended type of 4 by 6 inch (10 by
15 cm) photo paper. For more information, see recommended papers on
page 16. In addition, for best results, set the paper type and paper size
before printing. For more information, see set the paper type on page 17
and set the paper size on page 18.
Tip: Help prevent rips, wrinkles, curled or bent edges by storing
all media flat in a resealable bag. Extreme changes in
temperature and humidity might result in curled media that does
not work well in the HP PSC if the media is not stored properly.
1 Remove the output tray.
2 Remove all paper from the input tray.
Note: If the photo paper you are using has perforated tabs, load the photo
paper so that the tabs are closest to you.
3 Slide the stack of photo paper (short edge forward, glossy side down)
completely forward and to the far right side of the input tray until it stops.
Tip: Refer to the diagram on the input tray of your HP PSC for
further assistance on loading 4 by 6 inch (10 by 15 cm) photo
paper.
4 Slide the paper-length and paper-width guides inward against the stack of
photo paper until they stop. Make sure the paper is laying flat. Do not
overload the input tray; make sure the stack of photo paper fits within the
input tray and is no higher than the top of the paper-length guide.
5 Replace the output tray.
load postcards or Hagaki cards
The following describes the procedure for loading postcards or Hagaki cards
into your HP PSC.
1 Remove the output tray.
2 Remove all paper from the input tray, and then slide a stack of cards
forward into the input tray until it stops.
Make sure the print side faces down.