Filter
Top Products
reference guide
use the fax features
65
fax
4 Enter the fax number to assign to that entry, and then press OK.
Tip: To enter a three-second pause within a number sequence,
press the pound (#) button repeatedly, until a dash appears on the
color graphics display.
5 Enter the person’s or company’s name, and then press OK.
For more information on entering text, see enter text on page 62.
6 After Enter Another? appears, press 1 (Yes), if you want to set up another
number, or press 2 (No) to exit.
delete speed-dial entries
Follow these steps to delete an individual speed-dial entry.
1 Press Setup.
2 Press 2, then press 2 again.
This selects Speed Dial Setup and then selects Delete Speed Dial.
3 Press until the individual entry that you want to delete appears, and then
press OK.
control resolution and contrast
You can change the resolution and contrast of documents that you are sending.
Your changes revert to the default values after two minutes of inactivity, unless
you set them as the default. For information, see set new defaults on page 66.
Note: These settings do not affect copy settings. Copy resolution and copy
contrast are set independently from fax resolution and fax contrast. Also,
the settings you change from the front panel do not affect faxes sent from
your computer.
This section contains the following topics:
• change resolution on page 65
• change contrast on page 66
•set new defaults on page 66
change resolution
Resolution affects the transmission speed and quality of faxed documents. The
HP PSC only sends faxes at the highest resolution supported by the receiving fax
machine.
1 Load your original face down on the right front corner of the glass.
For more information, see load an original on page 11.
2 Press Fax.
The Enter Fax Number screen appears.
3 Enter the fax number.
4 Press Fax, and then press 1.
This displays the Fax Menu and then Resolution.