Filter
Top Products
Optical disk drive
NOTE: Read Warnings and cautions on page 59 before servicing this component.
This section describes how to remove and install an optical disk drive.
Removing an optical disk drive from the optical bay
1. Disconnect power from the workstation (see Predisassembly procedures on page 66).
2. Remove the side access panel (see
Removing the side access panel on page 69).
3. Remove the front bezel (see
Removing the front bezel on page 72).
4. Disconnect the data
and power
2
cables from the optical disk drive as shown in the following
figure.
Figure 5-11 Disconnecting optical disk drive cables
ENWW Removing and installing components 77