Filter
Top Products
Installing an optical disk drive in the optical bay
To install an optical disk drive:
1. Disconnect power from the workstation (see
Predisassembly procedures on page 66).
2. Remove the side access panel (see
Removing the side access panel on page 69).
3. Remove the front bezel (see
Removing the front bezel on page 72).
4. Lift the green release lever
and slide the optical disk drive into the bay until it is stopped by the
release latch as shown in the figure below.
Release the latch and continue sliding the drive until the latch closes and engages the drive
2
.
Figure 5-13 Installing the optical disk drive
TIP: During installation the adjacent drive or filler may move slightly. It might be necessary to
slide and align both devices to get the release latch to close and engage both devices.
5. Connect the power and data cables to the drive as shown in the following figure. (See the service
label on the Side access panel for component locations.)
ENWW Removing and installing components 79