Filter
Top Products
Removing a DIMM
To remove a DIMM:
1. Disconnect power from the workstation (see
Predisassembly procedures on page 66).
2. Remove the side access panel (see
Removing the side access panel on page 69).
CAUTION: To ensure that DIMMs are not damaged during removal or installation, power off the
workstation and unplug the power cord from the AC power outlet. If you do not unplug the power
cord before installing memory, the modules might be damaged and the workstation will not
recognize the memory changes.
3. Push gently outward on the DIMM socket levers as shown in the following figure.
Figure 5-20 Removing a DIMM
4. Lift the DIMM straight up
2
and out of the socket, then store the DIMM in an antistatic bag.
ENWW Removing and installing components 87