HP Designjet T Series — Service Manual 6-85
Removal and Installation - Right Spindle Holder and Rewinder (T1100/T1100ps/T610)
8. Remove the Right Spindle Holder (rewinder
included) from the printer.
Installation
1. Take note of the two clips that fit to the
printer.
2. Make sure the two clips fit correctly to the
printer.
44 inch T1100 printer shown (with Rewinder)
When you finish installing or replacing this component, you must perform the
necessary Service Calibrations. To find which calibrations you must perform,
see Service Calibration Guide to Removal and Installation
on page 6-5.
Make sure you carry out the following actions during the installation of the
Right Spindle Holder (rewinder included)