Filter
Top Products
HP Designjet T Series — Service Manual 6-137
Removal and Installation - Carriage Rear Bushing
Carriage Rear Bushing
Removal
1. Remove the Front Cover on page 6-16.
2. Remove the
Right Cover on page 6-27.
3. Remove the
Left Cover on page 6-30.
4. Remove the
Cutter Assembly on page 6-
42.
5. Remove the
Front Panel on page 6-47.
6. Remove the
Top Cover on page 6-50.
7. Remove the
Window Position Sensor on
page 6-53.
8. If the printer is a T1100/T1100ps/T610,
r
emove the
Ink Supply Tubes Support Rail
(T1100/T1100ps/T610) on page 6-55.
9. Remove the Encoder Strip, spring, and
at
tachment nut. See page
6-96 or 6-99
depending on the printer model.
10. Remove the Carriage Assembly. See page
6-116 or 6-127 depending on the printer
model.
11. Squeeze the left hand clip of the Carriage
Rear Bushing sufficiently to be able to
release it from the Carriage Assembly.
Switch off the printer and remove the power cable.