Filter
Top Products
HP Designjet T Series — Service Manual 2-17
System Error Codes - Full Descriptions
5 Perform the Service Station diagnostic test to troubleshoot the problem
further. See
8. Service Station on page 3-42.
6 Check that the Scan-Axis Motor cable is not damaged and is correctly
connec
ted to the PrintMech PCA.
7 Replace the Scan-Axis Motor. See
Scan-Axis Motor (T1100/T1100ps/
T610) on page 6-142 or Scan-Axis Motor (T1120/T1120ps) on page 6-
146.
8 If the System Error continues, replace the PrintMech PCA. See
PrintMech
PCA (T1100, T1100ps, T610 ONLY) on page 6-73.
System Error:
44:YZ (T1100/T1100ps/T610 ONLY)
Problem
Description:
The 44:10 system error signifies an electrical error with the Aerosol Fan, or a
connection error.
Please note that only T1100/T1100ps/T610 printers manufactured before
mid-F
ebruary, 2008, have aerosol fans.
Corrective Action: Try the following:
1 Did you replace the Formatter before the error occurred? Is the printer a
T11
00/T1100ps/T610? If so, see If the error occurred after replacing the
Formatter below.
2 S
witch the Power OFF from the back of the Printer and disconnect the Power
cor
d. Reconnect the power cord and power On the Printer.
3 Check that the Aerosol Fan cable is not damaged and is correctly connected
t
o the PrintMech PCA
4 Replace the Aerosol Fan Assembly. See
Aerosol Fan Assembly (T1100,
T1100ps, T610 ONLY) on page 6-71.
If the error occurred after replacing the formatter
As a design enhancement from mid February, 2008, the HP Designjet T
Seri
es printers do not include an Aerosol Fan.
A small quantity of printers manufactured after mid February, 2008, are
displa
ying the system error 44:10 if the formatter has been replaced,
because the formatter contains a previous firmware version (previous to
version 6) that checks for a fan connection.
Corrective Action
Check the serial number plate which is located at the rear of the printer. If
the pr
inter was built after mid February, 2008, replace the Formatter using
the following part numbers:
HP Designjet T1100 Printer: Q6683-60021 (or any formatter service kit
incl
uding fw 6 or superior)
HP Designjet T610 Printer: Q6711-60024 (or any formatter service kit
incl
uding fw 6 or superior)
If the printer was manufactured before mid-February, 2008 perform the
standard troubleshooting procedure above.