Filter
Top Products
Remove the laser/scanner assembly (C/Bk)
NOTE: After installing a new laser/scanner assembly, be sure to calibrate the product. See Calibrate
the product on page 313.
1. Release one spring (callout 1), and then disconnect one FFC (callout 2).
CAUTION: The spring is not captive. Do not lose the spring when it is removed. Use a pair of
needle-nose pliers to safely retain the spring when it is removed. Do not use a flat blade screwdriver
to remove the spring; the spring could forcibly leave the product and strike you.
Reinstallation tip When you reinstall the spring, make sure that the laser/scanner fits tightly up
against the product chassis, and make sure that the FFC is fully seated in the connector. The
locator tabs on the front of the scanner must be firmly seated in the slots in the chassis.
Figure 2-180 Remove the laser/scanner assembly (C/Bk) (1 of 5)
2
1
2. Disconnect one connector.
Figure 2-181 Remove the laser/scanner assembly (C/Bk) (2 of 5)
ENWW Internal assemblies 191