Filter
Top Products
Description Recommended action
TRAY <X> [TYPE] [SIZE]
To change size or type press OK
To accept settings press
This message states the current type and
size configuration of the tray.
To change size or type press the OK button.
To accept settings press the back arrow
.
TRAY <X> EMPTY [TYPE] [SIZE] The specified tray is empty and the current
job does not need this tray to print.
Refill the tray at a convenient time.
TRAY <X> OPEN The specified tray is open or not closed
completely.
Close the tray.
NOTE: If this message appears and the
lifter-base assembly was removed or
replaced, make sure that the connector on
the assembly is correctly connected and fully
seated.
TRAY <X> OVERFILLED
Remove some paper
The tray is filled above the stack-height
marking.
Remove enough paper so that the paper
stack does not exceed the limit for the tray.
NOTE: If this message appears and the
paper-pickup assembly was removed or
replaced, make sure that the connector at the
back of the assembly is correctly connected
and fully seated.
TRAY <X> OVERFILLED
To use another tray press OK
The tray is filled above the stack-height
marking.
Remove enough paper so that the paper
stack does not exceed the limit for the tray or
press OK to use another tray.
NOTE: If this message appears and the
paper-pickup assembly was removed or
replaced, make sure that the connector at the
back of the assembly is correctly connected
and fully seated.
TRAY <X> SIZE = <Size>
Media insert required in tray
The product is set to print on a small paper
size that requires the HP postcard media-
insert to be installed in this tray.
To use this size paper, install the media insert
before loading the paper.
If you do not have the HP postcard media
insert, 100 x 150 mm (4 x 6 in) paper can be
printed from Tray 1 without the insert.
TYPE MISMATCH IN TRAY X The specified tray contains a paper type that
does not match the configured type.
The specified tray will not be used until this
condition is addressed. Printing can continue
from other trays.
1. Load the correct paper in the specified
tray.
2. Verify the type configuration.
UNABLE TO COPY JOB The product does not have enough memory
to produce multiple original prints of this job.
One copy will be printed.
Add more memory to the product. See
Memory DIMM on page 81.
UNABLE TO STORE JOB A job cannot be stored because of a memory
or configuration problem.
Install additional memory in the product.
Unsupported data on [FS] DIMM in slot x
To clear press OK
The data on the DIMM for the indicated file
system is not a type that the product supports.
[FS] can be either a ROM or Flash file system.
Press the OK button to clear the message.
Replace the DIMM. See
Memory DIMM
on page 81.
Table 3-14 Control-panel messages (continued)
372 Chapter 3 Solve problems ENWW