Lifter-drive assembly (optional paper feeder)
Before proceeding, remove the following components:
●
Rear cover (optional paper feeder). See
Rear cover (optional paper feeder) on page 218.
Remove the lifter-drive assembly (optional paper feeder)
1. Disconnect one connector (callout 1), and then release the wire harnesses (callout 3) from the
guides (callout 2).
Figure 2-236 Remove the lifter-drive assembly (optional paper feeder) (1 of 2)
2
1
3
2. Remove two screws (callout 1), and then remove the sheet-metal plate (callout 2). Remove one
spring (callout 3), and then remove the lifter drive assembly.
Figure 2-237 Remove the lifter-drive assembly (optional paper feeder) (2 of 2)
1
2
3
230 Chapter 2 Removal and replacement ENWW