Pickup assembly (optional paper feeder)
Before proceeding, remove the following components:
●
Paper feeder right front cover. See
Right-front cover (optional paper feeder) on page 219.
●
Paper feeder rear cover. See
Rear cover (optional paper feeder) on page 218.
NOTE: The following procedure shows steps for removing the pickup assembly for Tray 3. 3 x 500-
sheet optional paper feeder only: The steps for removing the pickup assemblies for Tray 4 and Tray
5 are the same unless noted. You must remove the pickup assemblies in sequence beginning with the
pickup assembly for Tray 5.
Remove the pickup assembly (optional paper feeder)
1. Remove one screw (callout 1), and then remove the tray rail (callout 2).
Figure 2-229 Remove the pickup assembly (optional paper feeder) (1 of 5)
1
2
226 Chapter 2 Removal and replacement ENWW