Filter
Top Products
Description Recommended action
22 EMBEDDED I/O BUFFER OVERFLOW
To continue press OK
Too much data was sent to the embedded
HP Jetdirect print server.
Press the OK button to print the transferred
data. (Some data might be lost.)
Check the host configuration.
22 PARALLEL I/O BUFFER OVERFLOW
To continue press OK
The product's parallel buffer has overflowed. Press the OK button to print the transferred
data. (Some data might be lost.)
Check the host configuration.
22 PARALLEL SERIAL BUFFER
OVERFLOW
To continue press OK
The product's serial buffer has overflowed. Press the OK button to print the transferred
data. (Some data might be lost.)
Check the host configuration.
22 USB I/O BUFFER OVERFLOW
To continue press OK
The product's USB buffer has overflowed. Press the OK button to print the transferred
data. (Some data might be lost.)
Check the host configuration.
40 EIO X BAD TRANSMISSION
To continue press OK
The connection between the product and the
EIO card in the specified slot has been
broken.
Press the OK button to clear the error
message and continue printing.
Try to reinstall the EIO card.
40 EMBEDDED I/O BAD TRANSMISSION
To continue press OK
A temporary printing error has occurred. Press the OK button to clear the error
message. (Data will be lost.)
41.3 UNEXPECTED SIZE IN TRAY <X>
LOAD TRAY <X> [TYPE] [SIZE]
To use another tray press OK
This message appears even though the tray
is loaded with the correct paper size.
1. Run the sensor test in the sensor
monitor mode to verify that the cassette
media size switch is functioning
properly.
2. Reconnect the cassette media size
switch intermediate connector J57, and
connector J107 on the DC controller
PCA.
3. Replace the lifter assembly.
41.5 UNEXPECTED TYPE IN TRAY <X>
LOAD TRAY <X> [TYPE] [SIZE]
To use another tray press OK
This message appears even though the tray
is loaded with the correct paper size.
1. Reconnect the media sensor
intermediate connector J77, and
connector J131 on the DC controller
PCA.
2. Replace the registration assembly.
41.7 ERROR
To continue press OK
Printer error
●
X = 2; beam detected misprint
●
X = 7; media transport error
Turn the product off, and then on.
48.01 TRANSFER UNIT ERROR The transfer belt has dislocated during
printing.
Turn product off then on.
If the message persists, remove and reinstall
the transfer unit.
Table 3-14 Control-panel messages (continued)
ENWW Tools for troubleshooting 347