Filter
Top Products
●
SRA3 (Trays 3, 4, or 5 only)
●
B5 (ISO)
CAUTION: Do not print envelopes or unsupported sizes of paper from the 500-sheet trays. Print on
these types of paper only from Tray 1. Do not overfill the input tray or open it while it is in use. Doing so
can cause paper jams.
Load custom-size media into tray 2, 3, 4, or 5
To use custom media, change the size setting on the control panel to Custom and set the unit of
measure, X dimension, and Y dimension. See
Configure a tray to match print job settings
on page 111 for more information.
1. Slide open the tray from the product.
2. Load the print media as described in steps 2 through 4 of the “Load detectable (standard-size)
media into Tray 2, 3, 4, or 5” section. Then proceed to step 3 in this procedure.
3. Slide the tray into the product. The control panel shows the tray type and size configuration. To
specify specific custom dimensions, or if the type is not correct, touch Modify when the control
panel prompts to change the size or type.
Y
X
4. Select Custom, and then select the Unit of measure, X dimension and Y dimension for the custom
paper size.
5. Select the paper type and then touch Save.
6. If the configuration is correct, touch Save.
ENWW Load paper and print media 105