Filter
Top Products
Menu item Sub-menu item Values Description
Light Media Auto (default)
On
Prevents the fuser from wrapping with light paper. Set
this feature to On if you are frequently seeing Fuser
Delay Jam or Fuser Wrap Jam messages, especially
when printing on lightweight paper or on jobs with
heavy toner coverage.
Environment Normal (default)
Low Temp
Optimizes performance in extreme low temperature
environments. Set this feature to Low Temp if the
product is operating in a low-temperature environment
and you are having problems with print quality such as
blisters in the printed image.
Line Voltage Normal (default)
100V
Optimizes performance in low-voltage conditions. Set
this feature to 100V if the product is operating in a low-
voltage environment and you are having problems with
print quality such as blisters in the printed image.
Cleaning frequency Normal (default)
Alternate
Set this feature to Alternate if you are seeing defects in
the printed output that repeat at 38 mm (1.5 inch)
intervals. This feature increases the frequency at which
the C roller is cleaned. Setting this feature to
Alternate might also reduce printing speed and
increase the frequency of consumable replacement.
D-Blade bias Normal (default)
Alternate
Set this feature to Alternate if you are seeing short white
vertical lines in the printed output. The Alternate setting
might also cause dark spots in the printed output, so be
sure to test this setting on a few print jobs.
Waste Bin Normal (default)
Alternate
Try setting this feature to Alternate if you are seeing
lengthwise toner streaks in your printed output,
especially in jobs with low toner coverage.
Discharge Brush Off (default)
On
Enable this feature in low temperature and low humidity
environments if you are seeing specks of toner
scattered on double-sided jobs using light-weight paper
and longer than ten pages.
Background Off (default)
On
Turn this feature On if pages are printing with a shaded
background. Using this feature might reduce gloss
levels.
Heavy Mode 30 PPM (default)
24 PPM
The default setting is 30 PPM. Select the 24 PPM option
to reduce the speed and improve fusing on heavy
paper.
Tracking Control Off (default)
On
Improves color stability by adjusting the bias voltage.
This setting should remain On.
Restore Optimize Select this setting to return all the settings in the
Optimize menu to the factory default settings.
Resolution Image REt 4800
1200X600dpi
Select Image REt 4800 to produces fast, high-quality
printing that is appropriate for most print jobs
Select 1200X600dpi to produce the highest-quality
printing available, but it may slow print speed. This
setting may be useful for jobs that contain very thin lines
or fine graphics.
Color REt Enabled (default)
Disabled
Enable or disable Resolution Enhancement technology
(REt), which produces print output with smooth angles,
curves, and edges.
Table 2-16 Print Quality menu (continued)
50 Chapter 2 Control panel ENWW