Filter
Top Products
Menu item Sub-menu item Sub-menu item Values Description
Repeat Once (Default)
Continuous
Determines the number of times the test runs.
Print/Stop Test Continuous value
from 0 to 60,000
milliseconds.
Default: 0
Isolate faults by stopping the device during
the print cycle and observing where in the
process the image degrades. To run the test,
specify a stop time. The next job that is sent
to the device stops at the specified time in the
process.
Color Band Test Test Page Print Prints a page that helps identify arcing in the
high-voltage power supplies.
Copies Continuous value
from 1 to 30.
Default: 1
Specify the number of copies to print for the
Color Band test
Scanner Tests Lower Lamp
Sensors
ADF Input Motor
ADF Input Reverse
Flatbed Motor
ADF Read Motor
ADF Read Motor
Reverse
ADF Duplex
Solenoid
ADF LED Indicator
A service technician can use this menu item
to diagnose potential problems with the
device scanner.
Control Panel LEDs Verify that the components of the control
panel are functioning correctly.
Display
Buttons
Touchscreen
Finisher Tests Manual Sensor Test
Component Test
Table 2-17 Troubleshooting menu (continued)
ENWW Troubleshooting menu 57