Filter
Top Products
314 User Guide Integrated Lights-Out
GET_DIAGPORT_SETTINGS Return Messages
<DP_IP_ADDRESS value="192.168.142.56"/>
<RACK_INFO MODE="write">
<DP_NIC_SPEED value="100"/>
</LOGIN>
A possible GET_DIAGPORT_SETTINGS return message is:
<GET_DIAGPORT_SETTINGS>
<DP_SPEED_AUTOSELECT value="No"/>
<DP_NIC_SPEED value="100"/>
<DP_FULL_DUPLEX value="Yes"/>
<DP_SUBNET_MASK value="255.255.0.0"/>
</GET_DIAGPORT_SETTINGS >
MOD_DIAGPORT_SETTINGS
The MOD_DIAGPORT_SETTINGS command is used modify the diagnostic
port network settings on iLO. For this command to parse correctly, the
MOD_DIAGPORT_SETTINGS command must appear within a RACK_INFO
command block, and RACK_INFO MODE must be set to write. The user must
have the configure iLO privilege to execute this command.
Example:
<RIBCL VERSION="2.0">
<LOGIN USER_LOGIN="username" PASSWORD="password">
<MOD_DIAGPORT_SETTINGS>
<DP_SPEED_AUTOSELECT value="No"/>
<DP_FULL_DUPLEX value="Yes"/>
<DP_IP_ADDRESS value="192.168.142.56"/>
<DP_SUBNET_MASK value="255.255.0.0"/>
</MOD_DIAGPORT_SETTINGS>
</RACK_INFO>
</RIBCL>
MOD_DIAGPORT_SETTINGS Parameters
All of the following parameters are optional. If a parameter is not specified, then
the parameter value for the specified setting is preserved.