Scanner will not turn on
If the scanner will not turn on when you press the front panel scanner buttons, there
may be one of two reasons:
● The scanner may be turned off. Be sure the power cable is plugged in.
● The scanner may have been unplugged. Check to see that the power cable has
not become disconnected from the scanner or unplugged from the power source.
● Check to see that the ADF cable has not become disconnected from the scanner.
Scanner lamp stays on
The scanner lamp should time out and turn off automatically after a period of inactivity
(about 15 minutes). This is the Power Save mode.
Scanner does not scan right away
Check to be sure the power cord is plugged in.
If the scanner has not been used for a while, the scanner lamp might need to go
through a warm-up period before scanning can begin. If the scanner lamp needs to
warm up, it takes a moment after starting the software or pressing a scanner button
for scanning to begin.
Buttons appear not to work
After each step, start a scan to see if the buttons are working. If not, proceed with the
next step.
● A cable might be loose. Ensure that the USB cable, the ADF cable, and the
power cable are securely connected.
● Unplug the power cable from the power source, and then plug it back in.
● Ensure that the power cord is plugged in.
● Restart your computer.
● The buttons might be disabled. Try the following procedure:
– Open Control Panel, select Scanners and Cameras, and then select your
scanner model from the list.
– Open Properties, and then click the Events tab. From the Scanner events
list, select Scan Document button press.
– Ensure that the HP Scanning software option is selected.
– Windows 98 and Windows 2000: Ensure that the Disable Device Events
option is not selected.
– Windows Me and Windows XP: Ensure the Take No Action option is not
selected.
Chapter 5
22
HP Scanjet 8270 Document Flatbed Scanner