Filter
Top Products
Set Administration/Memory/Enable Disk Swap to Yes. Any extra
memory is distributed to all memory clients.
Take any memory, if available and not being used by other cli-
ents, and add it to the Administration/Memory/K Mem Display
memory setting.
▲ Caution:
This option should be used only by individuals who are
familiar with adjusting memory client’s values. Incorrect use of
this option could cause the system to operate incorrectly.
This field shows the size of the physical RAM installed in the printer. If
a hard disk is installed and disk swapping is enabled (Administration/
Memory/Enable Disk Swap), this field also gives the size of available
virtual memory.
Also known as System Use, this non-configurable client is the amount
of RAM used to run the printer’s operating system. It’s never
increased or decreased. The system memory subtracted from the
total amount of RAM identifies the amount of RAM available for all the
other memory clients.
You can add one internal IDE hard disk and up to three external SCSI
hard disks to your QMS 1660 Print System. These hard disks serve
as secondary storage places for such items as downloaded fonts,
emulations, and spooled data.
» Note:
Hard disk specifications are included in Q-FAX document 6502,
“QMS-tested SIMMs and Hard Disks.” This document contains a
description of each approved hard disk, its manufacturers and part
numbers, and the QMS products on which it can be used. See
appendix A, “QMS Customer Support,” of this manual to find out how
to access Q-FAX documents.