Filter
Top Products
While you can usually specify the orientation of a print job in your
application, if you consistently use a certain media orientation, you
can set this in the Operator Control/Orientation menu.
Even though there is only one outputbin, you may want to name it.
You can use this name with DOC commands. (See the
QMS Crown
Document Option Commands
manual, available for purchase from
your QMS vendor, for complete information on DOC commands.)
Use the Operator Control/Multipurpose Sz menu to identify the size
media in the multipurpose tray (inputbin 1).
Menu Operator Control/Orientation
Choices Portrait—Vertical
Landscape—Horizontal
Default Portrait
Menu Administration/Engine/Outputbin 1 Name
Choices Up to 16 characters
Default Upper