Filter
Top Products
» Note:
Before installing an internal IDE hard disk, you must have an
optional IDE-SCSI board.
If you’re installing an optional IDE-SCSI board for the first time,
refer now to “IDE-SCSI Board,” earlier in this section, for installation
instructions. You will be referred to these instructions at the
appropriate time.
If the IDE-SCSI board is already installed, you must remove it
before you can install an internal hard disk. Refer to the same section
for information on removing the board.
1 Connect one end of the plastic ribbon cable to the hard disk.
Align the colored stripe on the cable with pin 1 on the hard disk
connector, and then slowly push the cable onto the connector.
▲ Caution:
The plastic ribbon cable is fragile. Handle it gently.