Filter
Top Products
d Terminate the connection.
3 Type hibaud↵ to extract the ModeX files.
4 Set the PC’s baud rate to 38400 by typing
modex.exe↵
modex
#
38400 n 8 1↵
where
#
is 1-4. See the MODEX.DOC file for more information on
this program.
5 Turn on the printer, wait for IDLE to appear in the message
window, and then print an advanced status page.
This procedure should not change the current configuration set-
tings. However, the advanced status page provides a record of all
current configuration settings, so you can verify that they are the
same after the system software has been updated.
6 Take the printer off line.
7 Turn on the RTS and CTS hardware flow control settings.
a Access the Administration/Communications/Serial/Hdwe
Flow Ctl menu.
b Set RTS to On.
c Set CTS to On.
d Press the Online/Offline key to be prompted to save your
changes.
e Select Yes to Save Changes.
8 Access the Administration/Miscellaneous/New Flash Image
menu.
9 Select Yes in the New Flash Image menu.
The printer waits for the new system software (image) to be sent
via your PC’s parallel port. (YES remains in the message window
until the new image is sent.)