Filter
Top Products
3 Remove the screws securing the IDE-SCSI board to the rear
interface panel of the printer.
Save the screws. (You’ll use them when you reinstall the board.)
4 Remove the IDE-SCSI board from the plastic standoff and the
80-pin connector on the controller board.
To unlock the standoff, squeeze the tip between two fingers until
you can easily remove the board.
5 Install the internal hard disk.
If you’re installing an internal hard disk for the first time, use
the instructions in a following section, “Installing an Internal
Hard Disk.”
If you’re removing an internal hard disk at this time (for exam-
ple, if you are removing an IDE hard disk to install a Kanji IDE
hard disk), use the instructions in a following section,
“Removing an Internal Hard Disk,” and then use the instruc-
tions in the “Installing an Internal Hard Disk” section.
The internal IDE hard disk is identified by the hard disk device num-
ber DSK7.
The IDE hard disk assembly kit includes the following:
IDE hard disk
Plastic ribbon cable
4 screws
Only one internal IDE hard disk is supported. However, you can add
up to three external SCSI hard disks to the printer.