Filter
Top Products
Register Map for Process and Operation Type Variables
Set Point Program Register Maps
Revision 4 HC900 Hybrid Controller Communications User Guide 53
9/03
6.10 Set Point Program Register Maps
Summary
The SP Programmer parameters are listed according to category related to program status and interaction, other
programmer parameters and program segment mapping. A section is also provided to aid in configuring a SP
programmer and recipe interface for third party software.
Function Code Support:
Read – Function Code 3
Write – Function Code 16 (10 Hex)
Considerations and Methods for Downloading. Operating, and Reading Status of SP Programs:
A SP programmer interface can be developed (and recipes containing a SP profile can be created) in third
party software using the parameters listed in the following table.
In creating a SP Programmer interface showing a number of segments, a graphic display might include a
table referencing the maximum number of ramp/soak segments that you will be using for your process. The
parameters to be referenced for each segment are listed in Table 6-16 - Register Map (Ramp/Soak
Segments).
Programmer Numbers
The parameters that follow refer to SP Programmer 1. Table 6-10 lists the Starting and Ending addresses
for all of the SP Programmers.
Table 6-10 SP Programmer Addresses
Programmer Number Starting
Address
(Hex)
Starting
Address
(Decimal)
Ending
Address
(Hex)
Ending
Address
(Decimal)
SP Programmer 1 1E00 7681 1E0F 7696
SP Programmer 2 1E10 7697 1E1F 7712
SP Programmer 3 1E20 7713 1E2F 7728
SP Programmer 4 1E30 7729 1E3F 7744
SP Programmer 5 8000 32769 800F 32784
SP Programmer 6 8010 37785 801F 32800
SP Programmer 7 8020 32801 802F 32816
SP Programmer 8 8030 32817 803F 32832