Filter
Top Products
Register Map for Process and Operation Type Variables
Set Point Programmer Additional Values Register Map
58 HC900 Hybrid Controller Communications User Guide Revision 4
9/03
6.12 Set Point Programmer Additional Values Register Map
This table contains Additional Value Register addresses of SP Programmer #1. See the Global Register
Map - Table 6-1 for starting and ending addresses (hex) for SP Programmer #2 through SP
Programmer #8 Additional Value Register Map Addresses.
Table 6-14 Set Point Programmer #1 Additional Values Register Map Addresses
Address
(hex)
Register
(decimal)
Channel Number Access Notes
1F00 7937 Current Program Number R/W Floating Point
Indicates the present profile number in
use. This also allows entry of a profile
number from the HC900 stored profile
memory (if profiles have been stored in
the controller) and will retrieve the
profile data for a display showing a SP
profile segment table. Typically, when
recipes are downloaded from third party
software, this will be the number
generated by the Program Save Request
parameter
A write to this register loads the program
into the set point programmer function
block; if 0 is written, the function block’s
program is cleared.
1F02 7939 Program Save Request R/W Floating Point
Assigns profile parameters downloaded
to a profile number such as 1. This is
required by the HC900 to be the last
parameter downloaded. This
overwrites what is in this HC900 SP
Profile memory location on each
download of a new SP profile.
Saves the program into the archive.
Writing to this register is prohibited in the
run mode.
1F04 7941 Auxiliary Output R Floating Point
1F06 7943 Guaranteed Soak Low R/W Floating Point
Presets High Deviation setting in
engineering units.
Writing to this register is only
permissible in the reset or ready mode
1F08 7945 Guaranteed Soak High R/W Floating Point
Presets Low Deviation setting in
engineering units.
Writing to this register is only
permissible in the reset or ready mode
1F0A 7947 Restart Ramp Rate R/W Floating Point
Writing to this register is only
permissible in the reset or ready mode
1F0C 7949 Display High Range Limit R/W Floating Point
Writing to this register is only
permissible in the reset or ready mode