Filter
Top Products
Download New Firmware
Downloading Firmware using an HP-UX Workstation and a Terminal
83
3. Verify that LanProbe’s IP address, subnet mask, and default gateway
address, as displayed at the bottom of the Download Menu screen, are
correct. If you need to change the configuration information, press
0
to
return to the main menu and then press
1
to modify configuration options.
4. Press
1
from the Download Menu screen, and enter the filename to
download.
5. Press
2
and enter the IP address of the HP-UX workstation which is acting
as the tftp server.
6. Press
3
to download new LanProbe firmware and wait for LanProbe to
reboot automatically. It should take about 90 seconds to transfer the
firmware to LanProbe and for the automatic reboot to take place. The probe
relays will click at the end of the reboot process.
CAUTION
Do not reset, power-cycle, or reboot LanProbe immediately after the download
process. Doing this may cause your probe to be damaged. After the firmware file
has been downloaded to the probe, there will be a brief period (approximately
1 minute) while the probe is copying the firmware to the flash EPROM.
After the download process is complete, LanProbe reboots and starts running the
new firmware.
If an error occurs during the download process, LanProbe returns to the Main
Menu without storing the new firmware to memory.