Local Terminal Configuration
Using a Local Terminal
24
Figure 2-9: Display Interface Summary
Modify/View Serial Port Settin
g
s
You can view or modify LanProbe’s serial port settings by entering the Serial Port
number (port 2) into the Modify/View Interface Values Menu’s Port parameter.
The Serial Port configuration parameters are then shown along with their current
settings. Use the following procedure to configure LanProbe’s serial port:
1. Enter the LanProbe’s Serial Port number (port 2) into the Modify/View
Interface Values Menu’s Port parameter as shown in Figure 2-8 on page 21.
Display Interface Summary
Interface Port Type IP Address
------------ ---------- -----------
1.1/Ethernet Telemetry 15.6.72.216
1.2/Serial Not Applicable 0.0.0.0