Filter
Top Products
Installation
Installing the Probe
32
Installing the Probe
This section describes how to install your LanProbe. First decide which
installation method you are going to use and then install the probe using one of the
following methods:
“Table Installation” on page 33
“Rack or Cabinet Installation” on page 33
CAUTION
Do
not
attach the power cord and Agilent Power Module to LanProbe until the
probe is completely installed. If the power cord and Agilent Power Module are
already attached to LanProbe, remove them now (you will not lose any
configuration parameters). The probe does not have a power switch but becomes
operational when the power is attached.