Filter
Top Products
Installation
Installing the Probe
34
3. Place LanProbe in the left support shelf slot while aligning the two empty
screw holes (from Step 2 on page 33) with the two screw holes in the
support shelf. The correct alignment has the front of LanProbe facing out the
front of the support shelf, refer to Figure 3-11 on page 35.
4. Attach LanProbe to the support shelf with two 0.75” #M4 self-tapping
POZIDRIV screws. Refer to Figure 3-11 on page 35 for the correct
alignment.
5. Attach one Dual Lock Reclosable Fasteners‚ strip to the top of LanProbe,
being careful to place it in a location that will both allow for the alignment
of the power module to be inside the support shelf and to not block the
LanProbe vent holes, refer to Figure 3-11 on page 35.