Filter
Top Products
Bootp Server Configuration
52
Bootp Server Configuration
This chapter describes how to use the Bootp server method to configure the
Agilent 4986B Ethernet LanProbe so that it can communicate over the network.
This chapter assumes that you have already installed LanProbe, but have not
attached the power cord and Agilent Power Module (0950-2546). If you plan to
use the local terminal method of configuration, skip this chapter and refer to
Chapter 2 “Local Terminal Configuration”.
The following sections are covered in this chapter:
“Probe Configuration Using a Bootp Server” on page 53
“Bootp Server Setup on an HP or Sun System” on page 55
“Bootp Server Setup on a PC” on page 59
“Configuring the Bootptab File” on page 65